null Skip to main content

The L&B Lamp Belge (Belgian Lampe)

The L&B Lamp Belge | The English Lampe Belge, by Alex Marrack

The L&B Lamp Belge

The L&B Lamp Belge or Belgian Lampe

by Alex Marrack

Other articles by Alex Marrack
Centre Draught Oil Lamps English and European Models
English Lamp Belge

Photos and commentary by Miles Stair (below)

Patented in 1884 and manufactured in Liege by Lempereur & Bernard, L&B. These were widely sold in the USA by the Belgian Lamp Co, and marked on the winder knob L&B with a smiley-sun face. In the UK they were mainly sold by Lewtas of Manchester, the knob marked LM with a smiley sun face, and marked on the fount or filler cap 'Lampe Nationale'. A few are also found in the UK marked L&B.

(Full names: Joseph Lempereur. Lambert Bernard, from Herstal (Liege) was his brother-in-law.)

In the UK there was another, very different 'Lampe Belge' sold by the Midland Lighting Co, which is made in England, and although similar (it has a smiley face sun winder), with a similar looking burner, no parts are interchangeable. (This lamp will be covered later.)

L&B 20 line side draft smiley

The Example shown is a L&B marked one, in the form of a patterned brass drop-fount which fits into a bottom-ventilated ceramic vase to form a table lamp. Spares available for these lamps include Flame spreaders, wicks, chimneys, and four inch base shades.

(Note, these lamps have a slightly small chimney crown, some round English chimneys have a rim at the base which makes them too tight in these lamps, so they need to be checked before purchase.)

L B drop fount1

Close up pictures of the burner show correct placement and proportion of the spreader, also correct relative height of the support pin and inner/outer wick tubes. These lamps burn with a taller, narrower more 'wine glass' shaped flame than most others.

[Click on photos to enlarge them.]

L B burner1

L B burner2

These lamps have a fixed steel pin in the centre of the burner. This is in turn supported by a brass 'tripod' inside the draught tube. The top of the pin stands approx level with the top of the wick tubes. The spreader has a tubular leg that slides over this pin. Lamps often have this pin ripped out to accommodate electric fittings.

(Note from Miles: The pin system provides for very good draft around the flame spreader, but it is also the reason why the flame spreaders are often lost and Alex has to make them; the flame spreader is not attached to the lamp, it just sits over the pin. Tip over the lamp and the flame spreader falls off.)

L B pin

Photos and commentary by Miles Stair

L&B began making lamps prior to their 1884 patent for center draft lamps with flame spreaders. Indeed, L&B produced limited numbers of center draft lamps in 1883. These lamps are rare and are obvious due to the different shape of the font than subsequent lamps. The US Patent of Dec. 29.1884 by Joseph Lempereur and Lambert Bernard of Liege, Belgium (US Patent No. 333237) was clearly after the January 14, 1884 timble flame spreader patent of Leonard Hinkle (US Patent No. 292114). However, evidence exists (below) that L&B were making lamps using both pedestal and thimble flame spreaders in Europe prior to the introduction of flame spreaders in the US. Emil Wild of Berlin patented a lamp, chimney and flame spreader on August 19, 1884 (US Patent No. 303774).

The lamps shown below are mine except where noted.

L&b 1883 1 side

L&b 1883 3 foot

1883 L&B center draft fs

L&b 1883 2 burner

20''' L&B center draft, 1883. Note shape of font.

Above, signed cast brass foot. Below, dated flame spreader.Burner with flame spreader on 1883 20''' Center Draft lamp. Note wick winder is unique.

`

L&b 1879 18 ligne matador

L&b 1879 14 ligne 1

L&b 1883 flat wick

L&B 1879 side draft Matador. The font is the same as the 20''' above, missing only the draft tube.

L&B 1879 14''' side draft with thimble flame spreader.L&B 1879 - 1883 Flat wick lamp. Note upper half of font shape.

`

L&B 1879 to 1883 size comparison

Size comparison of the lamps above.

`

L&B good side

L B Belgian emb

LB Belgian 1883

Later model 20''' center draft.

Same model, embossed

1883 L&B, embossed, before restoration. Owned by Peter Brickell.

`

L&B 20 hanging

L B Hand Lamp

15 line L&B 1

L&B 20''' hanging lampL&B hand lamp, Owned by Peter Brickell.15''' L&B side draft.

20''' Matador compared.

At right, two L&B 20''' Matador burners.

The burner on the left has wick knob indicia "Matador 20''' ". The base of the burner is marked Matador 20''' * Importe D'Allemagne." This burner was apparently for the French market.

The burner on the right is marked on the wick knob "Lampereur & Bernard" with a small smiley face. This burner was apparently for the British market.

L&B 20 line side draft D`Allemagne Smiley

At right, the two burners above apart.

There are minor variations between the burners but that could reflect different years of production.

Click on the photos to enlarge them.

L&B 20 line side drafts compared

There are more photos of L&B burners on the Center Draft & Side Draft Lamp Wick Assembly page. Click here.

L&B US Patent #333,237, Dec. 29.1885. pdf file.

The English Lampe Belge, by Alex Marrack

ENGLISH LAMPE BELGE

by Alex Marrack
Other articles by Alex Marrack
Centre Draught Oil Lamps English and European Models
The L&B Lamp Belge or Belgian Lampe


The original patent for these lamps dates from 1884, and earlier examples are labelled Lampe Belge, and usually have plain brass wick knobs. Later examples are called 'Improved Lampe Belge' and show an 1893 patent. They are also usually labelled Thermidor Belge on the filler cap, and usually have an engraved black winder knob with a 'smiley-sun' trade mark and the legend 'In Lux Way'. Whilst they look very similar to the Belgian made lamps they are considerably heavier made, and were almost certainly made by the 'Midland Lighting Company' in Birmingham, England.

They share the same style of chimney grips with the Belgian product, and the burner baskets look similar. However, very few parts are interchangeable. The most usual size is the 20 line, though 15 line and 30 line are also to be found. The 20 line size is available in both raiser and non-raiser versions. Unusually, the burners cannot be swapped over, the raiser burner is taller, and will only work on a fount with the correct, taller, draught tube. This must have entailed a lot of extra stocking by factory and dealers, as every fount variety needed to be stocked in raiser and non-raiser version. It also prevented the customer from upgrading a lamp by buying a raiser burner should they suddenly feel wealthy enough!

English Lamp Belge1

English Lamp Belge2

English Lamp Belge3

English Lamp Belge table lamp

Complete burner showing flame spreader

Draft tubes and flame spreader support. Note the lift key.

The spreader looks similar to the Belgian lamps, but, as can be seen in the pictures, the support is in the form of a narrow tube, and the spreader has a brass pin, whereas the L&B Belge is the other way around. Two other English lamps (the Messengers 54cp and the English Juno) also share what is essentially the same spreader and support.

The majority of English Belge lamps are in the form of drop-founts for fitting into floor stand lamps, hangers and brackets, table lamp versions are relatively rare. These lamps are well made, and do not usually deteriorate unless abused. Spreaders are usually missing, and spreader supports are often ripped out for electrocution, with the draught tube often shortened as well.

Spares available for the 20''' size include wicks, flamespreaders, chimneys, shades and galleries. These lamps perform well and will accept the Round-English chimney.